Sony SU-WL500 Manual

10 

(GB)

If you intend to install a TV that is not specified on page 2, be 
sure to refer to its operating instructions, or the supplied 
leaflet.

Be sure to complete the installation before connecting the 
AC power cord to the wall outlet. If you allow the AC 
power cord to be pinched under or between pieces of 
equipment, this may result in a short circuit or an electric 
shock.
Be careful not to stumble over the AC power cord or the 
TV, as you may hurt yourself.

Connect the AC power cord and the connecting 
cable(s) to the connectors on the rear of the TV. For 
details on connecting the AC power cord and the 
connecting cable(s), refer to the instruction manual of 
the TV.

• You cannot connect the cables to the TV after installing it 

on the Base Bracket.

• Subcontract the cable routing in the wall to a licensed 

contractor.

1

Referring to the Screw and Hook locations 
diagram/table on page 13, determine the holes of 
the Base Bracket for latching the upper hooks of the 
Mounting Hook.

2

Hold the TV securely with both hands, and gently 
align it on the wall.

Be sure that two or more persons hold the TV when 
carrying it.

When using an electric screwdriver, set the torque setting to 
approximately 1.5 N·m {15 kgf·cm}.

1

2

Be sure to tighten both left and right securing 
screws firmly. If you fail to do so, the TV may fall 
when it is pushed upward and cause injury.