Sony SU-WL500 Manual

9 

(GB)

When using an electric screwdriver, set the torque setting 
to approximately 2 N·m {20 kgf·cm}.
Do not lift the Mounting Hook before the screws (two 
screws each for left/right) are secured. This may distort 
the Mounting Hook or the TV cabinet.

Referring to the Screw and Hook 
locations diagram/table on 
page 13, determine the screw 
positions, and secure the Mounting 
Hook to the rear of the TV.

1

Secure the Mounting Hook to the rear of the TV 
temporarily, using the supplied four screws 
(+PSW6 × 16).

2

Be sure that both screws are securely tightened with 
equal torque strength to the rear of the TV.

Be sure not to use any screws other than the supplied ones 
(+PSW6 × 16) when securing the Mounting Hook.

Align the tab on the rear of the Mounting Hook 
with the square hole on the rear of the TV as in 
the illustration below.

When installing the TV parallel to the wall (0 degrees), 
adjustment of the Mounting Hook angle (procedures 
1

 and 2 below) is not necessary. Make sure that each 

arm base X is screwed in securely.

1

Remove the two screws from the arm base X of the 
Mounting Hook. Choose the holes corresponding to 
the desired angle (5, 10, 15 or 20 degrees).

2

Adjust the angles of the top Y and bottom Z arm 
to fit the corresponding hole, and firmly secure each 
arm using the two screws removed in the previous 
procedure 1.

• Be sure to adjust the right and left arms to the same angle.
• Make sure that the two arm bases are screwed in securely.

Be careful not to pinch your fingers when adjusting the angle 
of the Mounting Hook.

• When installing TV models other than those 

specified on page 2 (depending on the model’s 
size and dimensions, etc.), the adjustment angles 
listed (0, 5, 10, 15, 20 degrees) for the arms may 
be limited.

• For the available adjustment angles of the arms 

when installing TV models other than those 
specified on page 2, refer to their operating 
instructions, or the supplied leaflet.