KitchenAid 1000-Watt Microwave with 7 Sensor Functions - 30" Guia Da Instalação

6.  Push microwave oven against mounting plate 

and hold in place.

NOTE: If microwave oven does not need to be adjusted, 

skip steps 7-9.
7.  If adjustment is required, rotate microwave oven downward. 

Using 2 or more people, lift microwave oven off of mounting 

plate, and set aside on a covered surface.

8.  Loosen mounting plate screws. Adjust mounting plate 

and retighten screws.

9.  Repeat steps 3-6.
10. With the microwave oven centered, and with at least one 

person holding it in place, insert bolts through upper cabinet 

into microwave oven. Tighten bolts until there is no gap 

between upper cabinet and microwave oven.

 

■

Some upper cabinets may require bolts longer or shorter 

than 3" (7.6 cm). Longer or shorter bolts are available 

at most hardware stores.

 

■

Overtightening bolts may warp the top of the microwave 

oven. To avoid warping, wood filler blocks (installer to 

provide) may be added. The blocks must be the same 

thickness as the space between the upper cabinet 

bottom and the microwave oven.

1.  Insert damper assembly through the cabinet cutout so 

that the long tab of the damper assembly slides under 

the raised tabs of the damper plate. Then secure with 

sheet metal screw.

NOTE: The screw cannot be installed if the damper assembly 

is not positioned as shown.

2.  Connect vent to damper assembly.

1.  Install filters. Refer to the User Instructions for 

filter placement.

2.  Plug microwave oven into grounded 3 prong outlet.
3.  Reconnect power.
4.  Check the operation of microwave oven by placing 1 cup 

(250 mL) of water on the turntable and programming 

a cook time of 1 minute at 100% power. Test vent fan 

and exhaust by operating the vent fan.

5.  If the microwave oven does not operate:

 

■

Check that a household fuse has not blown or that 

a circuit breaker has not tripped. Replace the fuse 

or reset the circuit breaker. If the problem continues, 

call an electrician.

 

■

Check that the power supply cord is plugged 

into a grounded 3 prong outlet.

 

■

See the User Instructions for troubleshooting information.

Installation is now complete.
Save Installation Instructions for future use.