KitchenAid 24.2 Cu. Ft. 42" Width Built-In Stainless French Door Refrigerator Guia Da Instalação

1. Check that the refrigerator door can open freely. If the door 

opens too wide, remove the door stop screw from the bottom 
hinge with a Torx

®†

 T15 screwdriver.

2. Hold the door open to a position that is less than 90°.

3. Replace the door stop screw in the bottom hinge and tighten.

IMPORTANT: Do not place the door stop screw in the 130° 
position on Overlay Series models. See “Handle and Door 
Clearances.”

1. Check that the refrigerator door can open freely. If the door 

opens too wide, you will have to adjust the door stop 
position. 

2. Grasp both ends of the top grille.

3. Push the top grille straight up, then pull straight out. Lay 

the grille on a soft surface.

4. The door stop is located on the top hinge.

5. Remove the two door stop screws.

■

To remove the outer screw (“A”): 

With the door closed, firmly press the L-shaped bracket 
toward the center of the refrigerator until the screw is 
exposed.

■

To remove the inner screw (“B”):

Open the door 90° and the L-shaped bracket will expose 
the screw.

6. Reverse or rotate the door stop to the desired position as 

shown below.

NOTE: For Overlay Series models, rout the hinge side of the 
custom door panels to a radius that is equal to at least half 
the thickness of the panel if a 130° door swing is desired.

A

A

B

C

B

B

A

130°

110°

B

A

C

A

B