KitchenAid 24.2 Cu. Ft. 42" Width Built-In Stainless French Door Refrigerator Guia Da Instalação

7. Replace the doorstop screws and tighten.

8. Check that the door can open freely.

Install Side Panel

If the built-in area depth is 25" (63.5 cm) or more, the side panels 
can be installed inside the side trim or attached to the outside of 
the side trim.

IMPORTANT: KitchenAid is not responsible for the removal or 
addition of molding or decorative panels that would not allow 
access to the refrigerator for service.

1. For the inside side trim piece, slide the front edge of the 

routed side panel into the trim piece.

2. Nail the rear edge of the panel to the support board. 

Install Base Grille

There are two pieces to the base grille to allow for a custom fit: 
the base grille itself and the skirt. The skirt can be added to the 
base grille in order to extend it all the way to the floor.

1. To see whether the skirt is needed, place the base grille into 

position. Do not attach the base grille to the refrigerator. 
Measure the distance between the bottom of the base grille 
and the floor. The gap must be a minimum of 

¹⁄₂" (1.27 cm) in 

order to add the skirt. 

NOTE: If the gap measures less than 

¹⁄₂" (1.27 cm), skip 

steps 3 and 4 of the instructions, and install the base grille 
only.

2. Remove the film from the base grille.

3. Snap the skirt onto the base grille.

4. Trim the skirt by scoring the proper “V” groove with a utility 

knife. Break the skirt at the score line.

90°

90°

A

B

A

B

A