KitchenAid 24" Double Wall Oven with True Convection Guia Da Instalação

Gather the required tools and parts before starting installation. 

Read and follow the instructions provided with any tools listed 

here.

■

 

Phillips screwdriver

■

 

Measuring tape

■

 

Level

■

 

Hand or electric drill (for 

wall cabinet installations)

■

 

1" (25 mm) drill bit (for wall 

cabinet installations)

■

 

UL-listed or CSA-approved conduit connector

■

 

UL-listed wire connectors

■

 

Four # 8-14 x 1" screws

■

 

Right and left side trim

■

 

Bottom vent (supplied on some models)

■

 

Bottom vent trim

■

 

Two # 8-18 x ³⁄

8

" screws – bottom vent

Check local codes. Check existing electrical supply.  

See “Electrical Requirements.”
It is recommended that all electrical connections be made  

by a licensed, qualified electrical installer.

IMPORTANT: Observe all governing codes and ordinances. 

■

 

Cabinet opening dimensions that are shown must be used. 

Given dimensions provide minimum clearance with oven.

■

 

Recessed installation area must provide complete 

enclosure around the recessed portion of the oven.

■

 

Grounded electrical supply is required. See “Electrical 

Requirements” section.

■

 

Electrical supply junction box should be located 3"  

(7.6 cm) maximum below the support surface when the 

oven is installed in a wall cabinet. A 1" (2.5 cm) minimum 

diameter hole should have been drilled in right rear or the 

left rear corner of the support surface to pass the appliance 

cable through to the junction box. 

  

NOTE: For undercounter installation, it is recommended 

that the junction box be located in the adjacent right or 

left cabinet. If you are installing the junction box on rear 

wall behind oven, the junction box must be recessed and 

located in the upper or lower right or left corner of the 

cabinet; otherwise, the oven will not fit into the cabinet 

opening.

■

 

Oven support surface must be solid, level, and flush with 

bottom of cabinet cutout. Floor must be able to support 

a single oven weight of 140 lbs (63.5 kg) or a double oven 

weight of 245 lbs (111.1 kg).

Ovens approved for this type of installation have an approval 

label located on the top of the oven. Refer to undercounter 

installation instructions for cutout dimensions and approved 

oven cooktop combinations (separate sheet).