KitchenAid 24" Double Wall Oven with True Convection Guia Da Instalação

■

 

If the house has aluminum wiring, follow the procedure 

below:

1.  Connect a section of solid copper wire to the pigtail 

leads.

2.  Connect the aluminum wiring to the added section  

of copper wire using special connectors and/or tools 

designed and UL listed for joining copper to aluminum.

Follow the electrical connector manufacturer’s  

recommended procedure. Aluminum/copper connection 

must conform with local codes and industry-accepted  

wiring practices.

1.   Decide on the final location for the oven. Locate existing  

wiring to avoid drilling into or severing wiring during  

installation.

2.   To avoid floor damage, set the oven onto cardboard prior  

to installation. Do not use handle or any portion of the front 

frame for lifting.
On models with shipping feet attached:
To avoid product damage, do not remove the shipping feet 

at the front lower corners of the oven. The shipping feet will 

protect the lower oven trim until the oven is inserted into 

cabinet.

3.   Remove the shipping materials and tape from the oven.
4.   Remove the hardware package from inside the bag  

containing literature.

5.   Remove and set aside racks and other parts from inside  

the oven.

6.   Move the oven and cardboard close to the oven’s final  

location.

If codes permit and a separate ground wire is used, it is 

recommended that a qualified electrical installer determine that 

the ground path and wire gauge are in accordance with local 

codes.
Check with a qualified electrical installer if you are not sure the 

oven is properly grounded.
This oven must be connected to a grounded metal, permanent 

wiring system.
Be sure that the electrical connection and wire size are 

adequate and in conformance with the National Electrical Code, 

ANSI/NFPA 70 – latest edition or CSA Standards C22.1-94, 

Canadian Electrical Code, Part 1 and C22.2 No. O-M91 – latest 

edition, and all local codes and ordinances.
A copy of the above code standards can be obtained from:

National Fire Protection Association  

1 Batterymarch Park 

Quincy, MA 02169-7471

CSA International 

8501 East Pleasant Valley Road 

Cleveland, OH 44131-5575

To properly install your oven, you must determine the type 

of electrical connection you will be using and follow the 

instructions provided for it here.

■

 

Oven must be connected to the proper electrical voltage 

and frequency as specified on the model/serial number 

rating plate. The model/serial number rating plate is located 

on the right mounting rail. See the following illustration.

■

 

Models rated from 7.3 to 9.6 kW at 240 volts (5.5 to  

7.2 kW at 208 volts) require a separate 40-amp circuit. 

Models rated at 7.2 kW and below at 240 volts (5.4 kW  

and below at 208 volts) require a separate 30-amp circuit.

■

 

A time-delay fuse or circuit breaker is recommended.

■

 

Connect directly to the fused disconnect (or circuit breaker 

box) through flexible, armored, or nonmetallic sheathed, 

copper cable (with grounding wire). See “Make Electrical 

Connection” section.

■

 

Flexible cable from the oven should be connected directly 

to the junction box.

■

Fuse both sides of the line.

■

 

Do not cut the conduit. The length of conduit provided  

is for serviceability of the oven.

■

 

A UL-listed or CSA-approved conduit connector must  

be provided.

IMPORTANT: Use both hands to remove oven doors.
1.   Open the oven door.
2.   Locate the oven door latches in both corners of the oven 

door, and rotate the latches forward to the unlocked  

position.