Netgear UTM9S – ProSECURE Unified Threat Management (UTM) Appliance with DSL and Wireless modules Manual De Referência
502
A
A.
xDSL Module for the UTM9S
This appendix describes how to configure the DSL interface of the UTM9SDSL xDSL module
that installs in an UTM9S. This appendix includes the following sections:
that installs in an UTM9S. This appendix includes the following sections:
Note:
The UTM9S has both WAN interfaces and a DSL interface. For
information about configuring the WAN interfaces of the UTM9S,
see
see
xDSL Module Configuration Tasks
Generally, six steps are required to complete the DSL Internet connection of your UTM9S.
Complete these steps:
1.
Configure the xDSL settings. Before you can configure the DSL Internet connection to
your ISP, you need to configure the xDSL settings. See
your ISP, you need to configure the xDSL settings. See
2.
Configure the Internet connection to your ISP. During this phase, you connect to your
ISP. See
ISP. See
3.
Configure the WAN mode. Select either NAT or classical routing, and select dedicated
(single WAN) mode, or, if you also have configured another WAN interface, auto-rollover
mode or load balancing mode. For load balancing, you can also select any necessary
protocol bindings. See
(single WAN) mode, or, if you also have configured another WAN interface, auto-rollover
mode or load balancing mode. For load balancing, you can also select any necessary
protocol bindings. See