Netgear M7100-24X (XSM7224) - ProSAFE 24 Ports 10G Fully Managed L2 Switch Guia Do Administrador
Switch Stacks
482
Managed Switches
Stack Switches Using Ethernet Ports and a Stack Cable
AX742 module
2/0/28
AX742 module
1/0/28
Stack cable
This example shows how to stack two switches at close range.
Figure 49. Using a stack cable to connect switches through their Ethernet ports
To set up a stack between two switches:
1.
Insert AX742 modules into both switches.
2.
Connect the AX 742 modules with a stack cable.
3.
Configure the Switch A and Switch B as described in one of the following sections:
•
•
CLI: Configure the Stack Ports as Ethernet Ports
1.
On Switch A, configure the stack port and reboot the switch.
(Netgear Switch) #show stack-port
Configured Running Link
Stack Stack Link Speed
Unit Intf SlotId Type XFP Adapter Mode Mode Status (Gb/s)
---- ----- ------ ------ ----------- ------- ------ ----- -----
2 0/27 None Stack Stack Link Down 0
2 0/28 AX742 (stack) Stack Stack Link Down 12
(Netgear Switch) #config
(Netgear Switch) (Config)#stack
(Netgear Switch) (Config-stack)#stack-port 2/0/28 ethernet
(Netgear Switch) (Config-stack)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) #reload
Are you sure you want to reload the stack? (y/n) y