Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa
IPv6 Commands
794
M4200 and M4300 Series ProSAFE Managed Switches
Loopback Interface Commands
The commands in this section describe how to create, delete, and manage loopback
interfaces. A loopback interface is always expected to be up. This interface can provide the
source address for sent packets and can receive both local and remote packets. The
loopback interface is typically used by routing protocols.
interfaces. A loopback interface is always expected to be up. This interface can provide the
source address for sent packets and can receive both local and remote packets. The
loopback interface is typically used by routing protocols.
To assign an IP address to the loopback interface, see
on page 633. To assign an
interface loopback
Use this command to enter the Interface Config mode for a loopback interface. The range of
the loopback ID is 0 to 7.
the loopback ID is 0 to 7.
no interface loopback
This command removes the loopback interface and associated configuration parameters for
the specified loopback interface.
the specified loopback interface.
show interface loopback
This command displays information about configured loopback interfaces.
If you do not specify a loopback ID, the following information appears for each loopback
interface on the system.
interface on the system.
Format
interface loopback loopback-id
Mode
Global Config
Format
no interface loopback loopback-id
Mode
Global Config
Format
show interface loopback [loopback-id]
Mode
Privileged EXEC
Term
Definition
Loopback ID
The loopback ID associated with the rest of the information in the row.
Interface
The interface name.
IP Address
The IPv4 address of the interface.