Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa
IPv6 Commands
795
M4200 and M4300 Series ProSAFE Managed Switches
If you specify a loopback ID, the following information appears.
IPv6 Routing Commands
This section describes the IPv6 commands you use to configure IPv6 on the system and on
the interfaces. This section also describes IPv6 management commands and show
commands.
the interfaces. This section also describes IPv6 management commands and show
commands.
ipv6 hop-limit
This command defines the unicast hop count used in ipv6 packets originated by the node.
The value is also included in router advertisements. Valid values for
The value is also included in router advertisements. Valid values for
hops are 1-255
inclusive. The default “not configured” means that a value of zero is sent in router
advertisements and a value of 64 is sent in packets originated by the node. Note that this is
not the same as configuring a value of 64.
advertisements and a value of 64 is sent in packets originated by the node. Note that this is
not the same as configuring a value of 64.
no ipv6 hop-limit
This command returns the unicast hop count to the default.
ipv6 unicast-routing
Use this command to enable the forwarding of IPv6 unicast datagrams.
Term
Definition
Interface Link
Status
Status
Shows whether the link is up or down.
IP Address
The IPv4 address of the interface.
MTU size
The maximum transmission size for packets on this interface, in bytes.
Default
not configured
Format
ipv6 hop-limit hops
Mode
Global Config
Format
no ipv6 hop-limit
Mode
Global Config
Default
disabled
Format
ipv6 unicast-routing
Mode
Global Config