Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa
IPv6 Commands
832
M4200 and M4300 Series ProSAFE Managed Switches
OSPFv3 Commands
This section describes the commands you use to configure OSPFv3, which is a link-state
routing protocol that you use to route traffic within a network. This section includes the
following subsections:
routing protocol that you use to route traffic within a network. This section includes the
following subsections:
•
•
•
•
•
Note:
OSPFv3 commands are supported on the M4300 series switches only.
Global OSPFv3 Commands
ipv6 router ospf
Use this command to enter Router OSPFv3 Config mode.
area default-cost (OSPFv3)
This command configures the monetary default cost for the stub area. For the value
argument, you must specify an integer value between 1–16777215.
argument, you must specify an integer value between 1–16777215.
area nssa (OSPFv3)
This command configures the specified area-id to function as an NSSA.
Format
ipv6 router ospf
Mode
Global Config
Format
area area-id default-cost value
Mode
Router OSPFv3 Config
Format
area area-id nssa
Mode
Router OSPFv3 Config