Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa
Quality of Service Commands
924
M4200 and M4300 Series ProSAFE Managed Switches
DiffServ Service Commands
Use the DiffServ service commands to assign a DiffServ traffic conditioning policy, which you
specified by using the policy commands, to an interface in the incoming direction
specified by using the policy commands, to an interface in the incoming direction
The service commands attach a defined policy to a directional interface. You can assign only
one policy at any one time to an interface in the inbound direction. DiffServ is not used in the
outbound direction.
one policy at any one time to an interface in the inbound direction. DiffServ is not used in the
outbound direction.
This set of commands consists of service addition or removal.
The CLI command root is
service-policy
.
service-policy
This command attaches a policy to an interface in the inbound direction as indicated by the
in
in
parameter, or the outbound direction as indicated by the out parameter, respectively. The
policyname
parameter is the name of an existing DiffServ policy. This command causes a
service to create a reference to the policy.
Note:
This command effectively enables DiffServ on an interface in the
inbound direction. There is no separate interface administrative mode
command for DiffServ.
inbound direction. There is no separate interface administrative mode
command for DiffServ.
Note:
This command fails if any attributes within the policy definition exceed
the capabilities of the interface. Once a policy is successfully attached
to an interface, any attempt to change the policy definition, that would
result in a violation of the interface capabilities, causes the policy
change attempt to fail.
the capabilities of the interface. Once a policy is successfully attached
to an interface, any attempt to change the policy definition, that would
result in a violation of the interface capabilities, causes the policy
change attempt to fail.
Note:
Each interface can have one policy attached.
no service-policy
This command detaches a policy from an interface in the inbound direction as indicated by
the in parameter, or the outbound direction as indicated by the out parameter, respectively.
The policyname parameter is the name of an existing DiffServ policy.
the in parameter, or the outbound direction as indicated by the out parameter, respectively.
The policyname parameter is the name of an existing DiffServ policy.
Format
service-policy {in | out} policymapname
Modes
Global Config
Interface Config