Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Administrador
iSCSI
677
Managed Switches
Set the iSCSI Target Port
When working with iSCSI that does not use the standard IANA assigned iSCSI ports
(3260/860), NETGEAR recommends that you specify the target IP address. Then, the switch
snoops frames only if the TCP destination port is one of the configured TCP ports and the
destination IP address is the target IP address. This configuration improves the performance
of the switch by preventing the CPU from processing non-iSCSI flows.
(3260/860), NETGEAR recommends that you specify the target IP address. Then, the switch
snoops frames only if the TCP destination port is one of the configured TCP ports and the
destination IP address is the target IP address. This configuration improves the performance
of the switch by preventing the CPU from processing non-iSCSI flows.
The example is shown as CLI commands and as web interface procedure.
CLI: Set iSCSI Target Port
Use the following commands to set iSCSI target port to 49154 at IP address 172.16.1.20.
Web Interface: Set iSCSI Target Port
1.
Configure the iSCSI target port.
a. Select Switching > iSCSI > Advanced > iSCSI Targets.
A screen similar to the following displays.
b. Enter the following information:
•
In the TCP Port field, enter 49154.
•
In the IP Address field, enter 172.16.1.20.
c. Click Apply to save the settings.
(Netgear Switch) #config
(Netgear Switch) (Config) #iscsi target port 49154 address 172.16.1.20
(Netgear Switch) (Config) #exit