Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa
Get Started
7
M4200 and M4300 Series ProSAFE Managed Switches Software Setup Manual
Prepare a Terminal if You Intend to Use a Console Port
If you intend to use one of the console ports for initial configuration of the switch, connect a
computer with a Windows, MAC, or Linux operating system and a terminal emulation
program or a VT100/ANSI terminal to one of the console ports on the switch.
computer with a Windows, MAC, or Linux operating system and a terminal emulation
program or a VT100/ANSI terminal to one of the console ports on the switch.
You can use one of the following console ports on the switch:
•
Mini USB console port. The switch comes with a mini USB to USB cable, which you can
use to connect the mini USB console port on the switch to a USB port on a computer with
a Windows, MAC, or Linux operating system or a VT100/ANSI terminal.
use to connect the mini USB console port on the switch to a USB port on a computer with
a Windows, MAC, or Linux operating system or a VT100/ANSI terminal.
Note:
To use the mini USB port, you must install the USB driver on the
computer. (The Windows USB driver is on the resource CD.)
computer. (The Windows USB driver is on the resource CD.)
•
RJ-45 RS232 console port. The RJ-45 RS232 serial port uses the following settings:
-
Baud rate. 115,200 bps
-
Data bits. 8
-
Parity. None
-
Stop bit. 1
-
Flow control. None
You can use the console cable that comes in the product package to connect the switch’s
RJ-45 RS232 console port to the DB9 port on the computer or VT100/ANSI terminal.
RJ-45 RS232 console port to the DB9 port on the computer or VT100/ANSI terminal.
Prepare a Computer With Terminal Emulation Software
If you use a computer with a Windows, MAC, or Linux operating system instead of a
VT100/ANSI terminal, configure the terminal emulation software:
VT100/ANSI terminal, configure the terminal emulation software:
•
On a computer with a Windows operating system, you can use HyperTerminal or Tera
Term.
Term.
•
On a computer with a MAC operating system, you can use ZTerm.
•
On a computer with a Linux operating system, you can use TIP.
To configure the terminal emulation software:
1.
Select one of the serial ports to connect to the console.
2.
Set the data rate, format, and flow control:
-
Baud rate. 115,200 bps
-
Data bits. 8
-
Parity. None
-
Stop bit. 1
-
Flow control. None
3.
Under Properties, select the correct mode.
4.
Select terminal keys.