Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa

You can use a locally or remotely attached terminal to access the switch through a console 
port.



Connect a computer with a Windows, MAC, or Linux operating system and a terminal 
emulation program or a VT100/ANSI terminal and open the appropriate COM port.

When the terminal interface initializes, the login user prompt displays.

Enter your user name and password.

The default user name is admin and the password is blank (that is, do not enter a 
password).

You can now access the switch with its default configuration.

For information about how to perform the initial configuration of the switch through either 
the CLI or the ezconfig tool, see the following sections:

Before you can use the switch in your network, you must set up its IP address configuration 
or find the DHCP-assigned IP addresses. The IP address configuration includes the IP 
address, subnet mask, and gateway of the management interface and the IP address, subnet 
mask, and gateway of the OOB port.

Set up the initial IP address configuration of the switch or find the DHCP-assigned IP 
addresses by using one of the following methods:

Web management interface. Use the web management interface through the OOB port 
or any Ethernet network port to access the switch over its default IP address and change 
the IP address configuration (see 

Use the web management interface for configuration instead of the CLI. 
Web configuration is quicker and easier than entering the multiple 
required CLI commands.

ezconfig. Use the ezconfig utility through the mini USB console port or RJ-45 RS232 
console port to access the switch and change the IP address configuration (see