Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Manual Do Utilizador
Configure System Information
111
M4200 and M4300 Series ProSAFE Managed Switches Web Management User Manual
Configure PoE
Configure Basic PoE
Note:
PoE is supported on models M4200-10MG-PoE+, M4300-28G-POE+,
and M4300-52G-POE+ only.
and M4300-52G-POE+ only.
To configure basic PoE settings:
1.
Launch a web browser.
2.
Enter http://<ipaddress> in the web browser address field.
The login window opens.
3.
Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
do not enter a password.
4.
Click the Login button.
The System Information page displays.
5.
Select System > PoE > Basic > PoE Configuration.
The Unit Selection field displays the current PoE unit.
6.
To change the PoE unit, select another unit from the list.
7.
To set the System Usage Threshold percentage, enter a number from 1 to 99.
This sets the threshold level at which a trap is sent if consumed power is greater than the
threshold power.
threshold power.
8.
The Power Management mode describes or controls the power management algorithm
used by the PSE to deliver power to the requesting PDs.
Select Static to indicate that the power allocated for each port depends on the type of
power threshold configured on the port. Select Dynamic to indicate that the power
consumption on each port is measured and calculated in real-time.
power threshold configured on the port. Select Dynamic to indicate that the power
consumption on each port is measured and calculated in real-time.
9.
To set the traps, select Enable to activate the PoE traps.
Select Disable to deactivate the PoE traps. The default setting is enabled.
10.
Click the Apply button.