Netgear GS752TPS(B) - ProSAFE 48-Port Gigabit Stackable Smart Switch with PoE and 4 SFP uplinks Manual Do Equipamento

Chapter 2. Physical Description

GS728TS, GS728TPS, GS752TS, and GS752TPS Smart Switch Hardware Installation Guide

SFP Port LEDs

The following table describes the dedicated SFP port LED designations. Each SFP port has
its own indication LED.

LED

Designation

SFP Mode for 2 Combo Ports:
SPD/Link/ACT LED

• Off—

No SFP module link is established.

• Solid Green —

A valid 1000Mbps SFP module link is established.

• Blinking Green —

The port is transmitting or receiving packets at

1000Mbps.

• Solid Yellow —

A valid 100Mbps SFP module link is established.

• Blinking Yellow —

The port is transmitting or receiving packets

100Mbps.

SFP Mode for last 4 SFP Ports:
SPD/Link/ACT LED

• Off—No SFP module link is established on the port.
• Solid Green—A valid 1000/2500Mbps SFP module link is established

on the port.

• Blinking Green—Packets transmission or reception is occurring on the

port at 1000/2500Mbps.

Note:

If the port media change to copper, the SFP port LED will change to

the OFF status.

System LEDs

The following table describes the system LED designations.

LED

Designation

Power

• Solid Green —

Device is powered on, run-time code is up and running.

• Solid Yellow —

Device is booting up.

• Off —

Power is not supplied to the device

Fan

• Solid Yellow

—

Fan has experienced a fail.

• Off

—

Fan is operating normally.

Stack Master LED

• Solid Green —

The switch acts as a master unit in a stack of GS700TS series

switches.

• Off

—

The switch acts as a slave in a stack of GS700TS series switches, or the

stack is operating in standalone mode.

Stack ID

Displays the stack ID, from 1 to 6.