Netgear GS752TPS(B) - ProSAFE 48-Port Gigabit Stackable Smart Switch with PoE and 4 SFP uplinks Guia Do Programa

To configure the settings and ping a host on the network:

In the Ping field, select either Global or Link Global to select either the global IPv6 
Address/Hostname or Link Local Address to ping.

Optionally, configure the following settings:

In the IPv6 Address/Host Name field, enter the IPv6 address or Hostname of the 

station you want the switch to ping. The initial value is blank. The IPv6 Address or 
Hostname you enter is not retained across a power cycle.

In the Datagram Size field, specify the size of the datagram to send. The valid range 

is 48–2048.

The Result field displays the result after the switch send a Ping IPv6 request to the 

specified IPv6 address.

Click Cancel to cancel the operation on the screen and reset the data on the screen to the 
latest value of the switch.

Click Apply to send the ping. The switch sends the number of pings specified in the Count 
field, and the results are displayed below the configurable data in the Result area. 

If successful, the output will be Send count=3, Receive count = n from (IPv6 

Address).Average round trip time = n ms.

If a reply to the ping is not received, the following displays: “Reply From IP/Host: 

Destination Unreachable. Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec”.

Traceroute

Use the Traceroute utility to discover the paths that a packet takes to a remote destination.

To display this page, click Maintenance > Troubleshooting > Traceroute.