Netgear S3300-28X (GS728TX) - ProSAFE S3300 Smart Switch Series Guia Do Administrador

The screens you access from the Ports menu allow you to view and monitor the physical port 
information for the ports available on the switch. The Ports menu contains links described in 
the following sections.

Use the Port Configuration screen to configure various characteristics about the physical 
ports or LAGs on the switch.



Select Switching 





 Port Configuration.

Select one or more ports or LAGs to configure.

For information about how to select and configure one or more ports and LAGs, see 

Configure or view the settings:

Description. Enter the description string to be attached to a port. The string can be 
up to 64 characters in length.

Admin Mode. Select the port control administration state, which can be one of the 

following:

Enable. You must select enable if you want the port to participate in the network. 
The default is enable.

Disable. The port is administratively down and does not participate in the 
network.

Auto-negotiation. Select to enable or disable auto-negotiation mode for this port.

After changing Auto-negotiation mode, the switch may be 

inaccessible for some seconds due to applying new settings.

Speed. Select the port’s speed. Possible values are:

Auto

 

—

  All supported speeds. If you select Auto, the duplex mode and speed will 

be set by the auto-negotiation process. The port’s maximum capability (full duplex 
and 1000 Mbps) will be advertised. Otherwise, your selection will determine the 
port’s duplex mode and transmission rate. The factory default is Auto.

10

  —

  10 Mbits/sec.

100

 

—

  100 Mbits/sec.

10G

 

—

  10 Gbits/sec.