Netgear XS728T – ProSAFE® 10 Gigabit Smart Managed Switch Guia Do Administrador
Routing
89
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
VLAN Routing
Use the VLAN Routing Configuration screen to view information about the VLAN routing
interfaces configured on the system or to assign an IP address and subnet mask to VLANs
on the system.
interfaces configured on the system or to assign an IP address and subnet mask to VLANs
on the system.
To configure VLAN routing settings:
1.
Select Routing > VLAN > VLAN Routing.
2.
In the VLAN list, Select the existing VLAN you want to configure for VLAN Routing.
The MAC Address field displays the MAC Address associated with the VLAN Routing
Interface.
Interface.
3.
In the IP Address field, enter an IP Address of the VLAN Routing Interface.
4.
In the Subnet Mask field, Enter a subnet mask for the VLAN Routing Interface.
5.
Click Add to add the VLAN Routing Interface specified in the VLAN ID field to the switch
configuration.
6.
Click Apply to send the updated configuration to the switch.
Configuration changes take place immediately.
Routing Table
From the Routing Table screen, you can configure static and default routes and view the
routes that the NETGEAR switch has already learned.
routes that the NETGEAR switch has already learned.
To configure routes:
1.
Select Routing > Routing Table.
2.
In the Route Type field, specify whether the route is to be a default route or a static route.
When you create a default route, all you need to specify is the next hop IP address.
3.
In the Network Address field, specify the IP route prefix for the destination.
To create a route, a valid routing interface must exist and the next hop IP Address must
be on the same network as the routing interface.
be on the same network as the routing interface.
4.
In the Subnet Mask field, indicate the portion of the IP address that identifies the attached
network.
5.
In the Next Hop IP Address field, specify The outgoing router IP address to use when
forwarding traffic to the next router (if any) in the path towards the destination.
The next router is always one of the adjacent neighbors or the IP address of the local
interface for a directly attached network.
When you create a route, the next hop IP must be on the same network as the routing
interface. Valid next hop IP addresses can be seen on the Route Table screen.
interface for a directly attached network.
When you create a route, the next hop IP must be on the same network as the routing
interface. Valid next hop IP addresses can be seen on the Route Table screen.
6.
In the Preference field, specify a preference value for the configured next hop.