Netgear XS728T – ProSAFE® 10 Gigabit Smart Managed Switch Guia Do Administrador

The VLAN Routing Wizard allows you to create a VLAN routing interface, configure the IP 
address and subnet mask for the interface, and add selected ports or LAGs to the VLAN. 
With this wizard, you can: 

Create a VLAN.

Add selected ports to the newly created VLAN and remove selected ports from the default 

VLAN.

Add selected LAGs to the newly created VLAN.

Enable tagging on selected ports if the port is in another VLAN. Disable tagging if a 
selected port does not exist in another VLAN.

Exclude ports not selected from the VLAN.

Enable routing on the VLAN using the IP address and subnet mask entered.



Select Routing > VLAN > VLAN Routing Wizard.

In the VLAN ID field specify a VLAN ID. 

This VLAN identifier (VID) associated with this VLAN is created if it does not exist. The 
valid range is 1–4093.

In the IP Address field, specify the IP address of the VLAN interface.

In the Network Mask field, specify the subnet mask of the VLAN interface.

Select the operation mode for ports and LAGs. 

The Port and LAG blocks each display selectable physical ports and LAGs (if any). 
Selected interfaces are added to the routing VLAN. Each interface can be configured to 
operate in one of three modes:

T (Tagged). Select the interfaces on which all frames transmitted for this VLAN are 
tagged. The interfaces that are selected are included in the VLAN.

U (Untagged). Select the interfaces on which all frames transmitted for this VLAN are 
untagged. The interfaces that are selected are included in the VLAN.

Blank (Autodetect). Select the interfaces that might be dynamically registered in this 
VLAN using GVRP. This selection has the effect of excluding an interface from the 
selected VLAN.

Click Apply to send the updated configuration to the switch.

Configuration changes take place immediately.