Netgear GS748Tv5 - ProSAFE 48-port Gigabit Smart Switch Guia Do Administrador
Configuring Switching
81
GS716Tv3, GS724Tv4, and GS748Tv5 Smart Switches
Ports
The screens you access from the Ports menu allow you to view and monitor the physical port
information for the ports available on the switch. The Ports menu contains links described in
the following sections.
information for the ports available on the switch. The Ports menu contains links described in
the following sections.
•
•
Port Configuration
Use the Port Configuration screen to configure various characteristics about the physical
ports or LAGs on the switch.
ports or LAGs on the switch.
To configure port settings:
1.
Select Switching
>
Ports
>
Port Configuration.
2.
Select one or more ports or LAGs to configure.
For information about how to select and configure one or more ports and LAGs, see
3.
Configure or view the settings:
•
Description. Enter the description string to be attached to a port. The string can be
up to 64 characters in length.
up to 64 characters in length.
•
Port Type. For most ports this field is blank. Otherwise, the possible values are:
-
Trunk Member. The port is a member of a LAG.
-
Mirrored. The port is a mirrored port.
-
Probe. The port is a monitoring port.
•
Admin Mode. Select the port control administration state, which can be one of the
following:
following:
-
Enable. The port can participate in the network (default).
-
Disable. The port is administratively down and does not participate in the
network.
•
Port Speed. Select the port’s speed and duplex mode. If you select Auto, the duplex
mode and speed will be set by the auto-negotiation process. The port’s maximum
capability (full duplex and 1000 Mbps) will be advertised. Otherwise, your selection
will determine the port’s duplex mode and transmission rate. The factory default is
Auto.
mode and speed will be set by the auto-negotiation process. The port’s maximum
capability (full duplex and 1000 Mbps) will be advertised. Otherwise, your selection
will determine the port’s duplex mode and transmission rate. The factory default is
Auto.
•
Physical Status. Indicates the physical port’s speed and duplex mode
•
Link Status. Indicates whether the link is up or down.