Netgear FS526Tv2 - 24-Port Smart Switch with Gigabit Ports Guia Do Utilizador
Switch Management Tools
285
ProSAFE FS526Tv2, FS726Tv2, and FS728TLP Smart Switches
WARNING:
During a system reboot, do not try to go online, turn off the smart
switch, shut down the computer, or do anything else to the smart
switch until the smart switch finishes rebooting and the Login
screen displays!
switch, shut down the computer, or do anything else to the smart
switch until the smart switch finishes rebooting and the Login
screen displays!
Return the Smart Switch to Factory Default Settings
Reset the smart switch to factory default settings if the smart switch has become
unresponsive or if you want to start a clean configuration. The firmware is not reset to the
firmware that was loaded at the factory. After you have reset the smart switch to factory
default settings, the firmware that was the active firmware before the reset remains the active
firmware after the reset.
unresponsive or if you want to start a clean configuration. The firmware is not reset to the
firmware that was loaded at the factory. After you have reset the smart switch to factory
default settings, the firmware that was the active firmware before the reset remains the active
firmware after the reset.
If you have lost the password that provides access to the web management interface, you
cannot use this procedure but need to use the Factory Default button on the front panel of the
switch. For more information, see the hardware installation guide for your model.
cannot use this procedure but need to use the Factory Default button on the front panel of the
switch. For more information, see the hardware installation guide for your model.
If you reset the switch to the default configuration, the IP address is reset to 192.168.0.239,
and the DHCP client is enabled. If you lose network connectivity after you reset the switch to
the factory defaults, see
and the DHCP client is enabled. If you lose network connectivity after you reset the switch to
the factory defaults, see
29.
To reset the smart switch to factory default settings:
1.
Select Maintenance > Reset > Factory Default.
The Factory Default screen displays.
2.
Select the check box.
3.
Click the Apply button.
The smart switch reboots and resets to factory default settings. The screen displays the
following message: System reboot ... Please wait 2 minutes. After two minutes, the Login
screen displays.
following message: System reboot ... Please wait 2 minutes. After two minutes, the Login
screen displays.