Netgear FS526Tv2 - 24-Port Smart Switch with Gigabit Ports Guia Do Utilizador
Connect the Smart Switch to Your Network
29
ProSAFE FS526Tv2, FS726Tv2, and FS728TLP Smart Switches
Connect the Smart Switch to the Network
To enable remote management of the smart switch through the web management interface
or SNMP, you need to connect the smart switch to the network and configure it with network
information (an IP address, subnet mask, and default gateway). The smart switch has a
default IP address of 192.168.0.239 and a default subnet mask of 255.255.255.0.
or SNMP, you need to connect the smart switch to the network and configure it with network
information (an IP address, subnet mask, and default gateway). The smart switch has a
default IP address of 192.168.0.239 and a default subnet mask of 255.255.255.0.
To change the default network information on the smart switch, use one of the following three
methods:
methods:
•
Dynamic assignment through DHCP. DHCP is enabled by default on the smart switch.
If you connect the smart switch to a network with a DHCP server, the smart switch
obtains its network information automatically. Use the Smart Control Center to discover
the automatically assigned network information.
If you connect the smart switch to a network with a DHCP server, the smart switch
obtains its network information automatically. Use the Smart Control Center to discover
the automatically assigned network information.
.
•
Static assignment through the Smart Control Center. If you connect the smart switch
to a network that does not have a DHCP server, use the Smart Control Center to assign a
static IP address, subnet mask, and default gateway.
to a network that does not have a DHCP server, use the Smart Control Center to assign a
static IP address, subnet mask, and default gateway.
.
•
Static assignment by connecting from local computer. If you do not want to use the
Smart Control Center to assign a static address, you can connect to the smart switch
from a computer (administrative system) in the 192.168.0.0/24 network and change the
settings by using the web management interface on the smart switch.
Smart Control Center to assign a static address, you can connect to the smart switch
from a computer (administrative system) in the 192.168.0.0/24 network and change the
settings by using the web management interface on the smart switch.
For information about how to set the IP address on the computer so it is in the same
subnet as the default IP address of the smart switch, see
subnet as the default IP address of the smart switch, see
34.
Use Automatic Switch Discovery for a Network with a DHCP
Server
Server
This section describes how to set up your smart switch in a network that has a DHCP server.
The DHCP client on the smart switch is enabled by default. When you connect the smart
switch to your network, the DHCP server automatically assigns an IP address to the smart
switch. Use the Smart Control Center to discover the IP address that is automatically
assigned to the smart switch.
The DHCP client on the smart switch is enabled by default. When you connect the smart
switch to your network, the DHCP server automatically assigns an IP address to the smart
switch. Use the Smart Control Center to discover the IP address that is automatically
assigned to the smart switch.