Netgear FVS318N – Prosafe Wireless N VPN Firewall Folheto
System Mode Configuration Commands
162
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
system-config[telnet]> enable_ipv6 Y
system-config[telnet]> access_type6 IP_Range
system-config[telnet]> from_address6 FEC0::3001
system-config[telnet]> end_address6 FEC0::3100
system-config[telnet]> save
Related show command:
SNMP Commands
system snmp trap configure <ip address>
This command configures a new or existing SNMP agent to which trap information is
forwarded. After you have issued the system snmp trap configure command to specify
the IP address of the agent, you enter the system-config [snmp-trap] mode, and then you can
configure one keyword and associated parameter or associated keyword at a time in the
order that you prefer.
forwarded. After you have issued the system snmp trap configure command to specify
the IP address of the agent, you enter the system-config [snmp-trap] mode, and then you can
configure one keyword and associated parameter or associated keyword at a time in the
order that you prefer.
Step 1
Format
Mode
system
Step 2
Format
agent <ipaddress>
Mode
system-config [snmp-trap]
Keyword
Associated
Parameter to Type
Parameter to Type
Description
The subnet mask used to determine the list of allowed SNMP
agents that are part of the subnet. To allow any IP address on the
network to manage the device, specify 255.255.255.0. For a
specific host, specify 255.255.255.255. To allow global access,
specify 0.0.0.0.
agents that are part of the subnet. To allow any IP address on the
network to manage the device, specify 255.255.255.0. For a
specific host, specify 255.255.255.255. To allow global access,
specify 0.0.0.0.
The SNMP port (integer) to which the trap messages are
forwarded. Valid numbers are from 0 to 65535.
forwarded. Valid numbers are from 0 to 65535.
The string that represents the community to which the agent
belongs. Most agents are configured to listen for traps in the public
community.
belongs. Most agents are configured to listen for traps in the public
community.
This keyword and parameter allow you to change the existing
agent IP address that you issued to enter the system-config
[snmp-trap] mode.
agent IP address that you issued to enter the system-config
[snmp-trap] mode.
system snmp trap configure <ipaddress>
subnet_mask <subnet mask>
port <number>
community <community name>
subnet_mask
subnet mask
port
number
community
community name
agent
ipaddress