Netgear FVS318N – Prosafe Wireless N VPN Firewall Leaflet

system-config[telnet]> enable_ipv6 Y 

system-config[telnet]> access_type6 IP_Range 

system-config[telnet]> from_address6 FEC0::3001 

system-config[telnet]> end_address6 FEC0::3100 

system-config[telnet]> save

SNMP Commands

This command configures a new or existing SNMP agent to which trap information is 
forwarded. After you have issued the system snmp trap configure command to specify 
the IP address of the agent, you enter the system-config [snmp-trap] mode, and then you can 
configure one keyword and associated parameter or associated keyword at a time in the 
order that you prefer.

system

agent <ipaddress>

system-config [snmp-trap]

The subnet mask used to determine the list of allowed SNMP 
agents that are part of the subnet. To allow any IP address on the 
network to manage the device, specify 255.255.255.0. For a 
specific host, specify 255.255.255.255. To allow global access, 
specify 0.0.0.0.

The SNMP port (integer) to which the trap messages are 
forwarded. Valid numbers are from 0 to 65535.

The string that represents the community to which the agent 
belongs. Most agents are configured to listen for traps in the public 
community.

This keyword and parameter allow you to change the existing 
agent IP address that you issued to enter the system-config 
[snmp-trap] mode.

system snmp trap configure <ipaddress> 

subnet_mask <subnet mask>

port <number>

community <community name>