Netgear FS516 - 16 Port 10/100 Mbps Fast Ethernet Switch Guia Da Instalação
Installation Guide for the Model FS516 Fast Ethernet Switch
2-2
Physical Description
Fast Ethernet Ports
As
shows, the Model FS516 switch is equipped with 16 autosensing
10/100 Mbps Fast Ethernet ports. The network access speed for the 10/100 Mbps ports is
automatically sensed and displayed on the front panel by the 100 Mbps LEDs.
automatically sensed and displayed on the front panel by the 100 Mbps LEDs.
The 10/100 Mbps ports support only unshielded twisted pair (UTP) cable using an 8-pin RJ-45
plug.
plug.
Each of the 10/100 Mbps ports uses vista RJ-45 connectors that have built-in LEDs, as illustrated
in
in
and that the port is operating in full-duplex mode.
.”
Key:
1 = Link LED
2 = FDX LED
2 = FDX LED
Figure 2-2.
The Vista RJ-45 Connector with Built-In LEDs
Normal/Uplink Push Button
The Normal/Uplink push button on the front panel of the switch, as illustrated in
,
allows you to select uplink (MDI) or normal (MDI-X) wiring for port 16 on the Model FS516
switch. This port is configured for normal wiring to connect to a PC when the push button is in
the out position. When the push button is pressed in, this port is configured for uplink wiring to
connect to another switch or to a hub, using a straight-through twisted pair cable.
switch. This port is configured for normal wiring to connect to a PC when the push button is in
the out position. When the push button is pressed in, this port is configured for uplink wiring to
connect to another switch or to a hub, using a straight-through twisted pair cable.
735EA
1
2