Netgear R7100LG - Nighthawk 4G LTE Modem Router Manual Do Utilizador

You can connect to the router network through a wired or WiFi connection. If you set up your computer to
use a static IP address, change the settings so that it uses Dynamic Host Configuration Protocol (DHCP).

You can connect your computer to the modem router using an Ethernet cable and join themodem router’s
local area network (LAN).

Make sure that the router is receiving power (its Power LED is lit).

Connect an Ethernet cable to an Ethernet port on your computer.

Connect the other end of the Ethernet cable to one of the numbered Ethernet ports.

Your computer connects to the local area network (LAN). A message might display on your computer
screen to notify you that an Ethernet cable is connected.

You can connect to the modem router’s WiFi network with Wi-Fi Protected Setup (WPS) or you can find and
select the WiFi network.

Make sure that the router is receiving power (its Power LED is lit).

Check the WPS instructions for your WiFi-enabled computer or mobile device.

Press the WPS button on the router.

Within two minutes, on your WiFi-enabled computer or mobile device, press its WPS button or follow
its instructions for WPS connections.

Your WiFi-enabled computer or mobile device connects to the WiFi network.

Make sure that the modem router is receiving power (its Power LED is lit).

On your WiFi-eabled computer or mobile device, find and select the WiFi network.

The WiFi network name is on the label on the modem router.

Join the WiFi network and enter the WiFi password.

The password is on the label on the router.

Your WiFi-enabled computer or mobile device connects to the WiFi network.