KitchenAid 36" Designer Commercial-Style Hood Ilustrações Dimensionais

A 120 Volt, 60 Hz., AC only, 15-amp, fused electrical circuit is required.

IMPORTANT: Observe all governing codes and ordinances. Have a qualified
technician install the range hood. It is the installer's responsibility to comply with
installation clearances specified on the model/serial rating plate. The model/serial
rating plate is located inside the range hood on the rear wall of the range hood.

Canopy range hood location should be away from strong draft areas, such as
windows, doors and strong heating vents.

Cabinet opening dimensions that are shown must be used. Given dimensions
provide minimum clearance.

The canopy range hood is factory set for venting through the roof or through the
wall.

All openings in ceiling and wall where canopy range hood will be installed must
be sealed.

For Mobile Home Installations
The installation of this range hood must conform to the Manufactured Home
Construction Safety Standards, Title 24 CFR, Part 328 (formerly the Federal
Standard for Mobile Home Construction and Safety, Title 24, HUD, Part 280) or
when such standard is not applicable, the standard for Manufactured Home
Installation 1982 (Manufactured Home Sites, Communities and Setups) ANSI
A225.1/NFPA 501A*, or latest edition, or with local codes.

A 6" (15.2 cm) round vent system is needed for installation (not included). The
range hood exhaust opening is 6" (15.2 cm) round. Two 6" (15.2 cm) round vent
systems are needed for installation on 48" (121.9 cm) models. 
NOTE: Flexible vent is not
recommended. Flexible vent
creates back pressure and air
turbulence that greatly reduce
performance.
Vent system can terminate either
through the roof or wall. To vent
through the wall, a 90º elbow is
needed.
*The 48" (121.9 cm) range hood

uses two 6" (15.2 cm) round
vents or transitions to 10" 
(25.4 cm) round vent using Part
Number 4396915.

Because Whirlpool Corporation policy includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.

Ref. W10233970D

10/22/09

®

The maximum equivalent vent lengths are:

6" (15.2 cm) round vent - 35 ft (10.7 m)
7" (17.8 cm) round vent - 40 ft (12.2 m)
8" (20.3 cm) round vent - 50 ft (15.2 m)
9" (22.9 cm) and 10" (25.4 cm) round vents - 60 ft (18.3 m)

The following example falls within the maximum recommended vent
length.

1 - 90° elbow
1 - wall cap
8 ft (2.4 m) straight

= 5.0 ft (1.5 m)
= 0.0 ft (0.0 m)
= 8.0 ft (2.4 m)

Length of system

= 13.0 ft (3.9 m)

Page 1 of 2

A

A

B*

B*

Calculating Vent System Length
To calculate the length of the system you need, add the equivalent feet (meters)
for each vent piece used in the system.

45° elbow

2.5 ft (0.8 m)

90° elbow

5.0 ft (1.5 m)