KitchenAid 5 Elements Pure Ceramic Glass Surface Architect® Series II Guia Da Instalação

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.

■

Clamp brackets (2)

■

2

¹⁄₂" (6.4 cm) clamping screws (2)

■

Foam strip

■

A UL listed or CSA approved conduit connector

■

UL listed wire connectors

Check local codes. Check existing electrical supply. See 
“Electrical Requirements.”

It is recommended that all electrical connections be made by a 
licensed, qualified electrical installer.

Make sure you have everything needed for correct installation. It 
is the responsibility of the installer to comply with the installation 
clearances specified in these instructions.

IMPORTANT: Observe all governing codes and ordinances. 
When installing cooktop, use minimum dimensions given.

■

To eliminate the risk of burns or fire by reaching over the 
heated surface units, cabinet storage space located above 
the surface units should be avoided. If cabinet storage is to 
be provided, the risk can be reduced by installing a range 
hood that projects horizontally a minimum of 5" (12.7 cm) 
beyond the bottom of the cabinets.

■

The cooktop must be a specified cooktop that is approved to 
be installed either alone or over an undercounter built-in 
oven. Check the cooktop base for an approved installation 
label for your cooktop model number and approved 
combinations of cooktops and ovens that can be installed. If 
you do not find this label, your cooktop may not be approved 
for use over an undercounter built-in oven. Contact your 
dealer to confirm that your cooktop is approved.

■

Ovens approved for this type of installation will have an 
approval label located on the top of the oven. If you do not 
find this label, contact your dealer to confirm that your oven is 
approved. Refer to oven manufacturer’s Installation 
Instructions for approval for built-in undercounter use and 
proper cutout dimensions.

■

When installing cooktop over an undercounter built-in oven, 
do not fasten cooktop to countertop with clamps. This will 
make the cooktop easier to remove if future servicing 
becomes necessary.

■

Use the countertop opening dimensions that are given with 
these Installation Instructions. Given dimensions are 
minimum clearances and provide 0" (0 cm) clearance.

■

Grounded electrical supply is required. See “Electrical 
Requirements” section.

■

Tape measure

■

Screwdriver

■

Level

■

Marker or pencil

■

Pliers

⁵⁄₁₆" (54.1 cm)

⁹⁄₁₆" (42.1 cm)

⁵⁄₁₆" (77.1 cm)

⁵⁄₁₆" (92.3 cm)

⁷⁄₈" (7.3 cm)

¹⁄₈" (56.1 cm)

⁹⁄₁₆" (42.1 cm)

⁵⁄₁₆" (77.1 cm)

⁵⁄₁₆" (92.3 cm)

⁷⁄₈" (7.3 cm)

C

A

B

A

B

C