Xerox Phaser EX7750 Guia Da Instalação

The EX7750 searches the network for AppleTalk zones in your network segment. 
Scroll through the list to select the AppleTalk zone in which you want the EX7750 to 
appear. If your segment has only one zone, the EX7750 is assigned to that 
zone automatically.

The message “No AppleTalk zone found” may mean your network has no zones, or the 
network cable is not connected (see 

). Choose OK to dismiss the message.

When you set an IP address, subnet mask, or gateway address for the EX7750 during 
Setup, you can allow the EX7750 to get these addresses automatically from a DHCP 
or BOOTP server. Turn on or restart the EX7750 and allow it to reach Idle. Make 
sure the DHCP or BOOTP server is running, and then perform EX7750 Setup.

To configure the EX7750 for TCP/IP, choose TCP/IP Setup.

Choose Ethernet Setup and enter the appropriate settings. Choose each network 
type you use (Ethernet) and enter the appropriate settings.