Xerox Phaser EX7750 Guia Da Instalação

Select Yes to allow the EX7750 to obtain its Ethernet IP address by searching the 
network. Depending on your network and the protocol you select in the following 
option (DHCP or BOOTP), the IP address can change. Select No to assign the 
EX7750 a static IP address. If you select No, you proceed to the IP Address option, 
where you manually set the IP address. 

This option appears only if you answered Yes to Enable Auto IP Configuration. Select 
the protocol over which the EX7750 should search for its IP address. Both DHCP and 
BOOTP allow the EX7750 to obtain the Ethernet IP address and Subnet Mask 
automatically. 

Depending on your network, the EX7750 may be assigned a different address after you 
restart the EX7750. With the DHCP setting, the EX7750 can be assigned a different 
address even if it is not restarted. Make sure the network is already configured properly 
for the protocol you select.

Network Setup

Protocol Setup

TCP/IP Setup

Select Yes if you have a TCP/IP network connected to the EX7750 over 
Ethernet cabling.

If you are using TCP/IP for printing from Windows computers, enabling 

TCP/IP here also enables you to use Fiery utilities from Windows computers using 
TCP/IP protocols.