Xerox DocuColor 12 Printer with Fiery EX12 Guia Da Instalação
DOCUCOLOR 12 CUSTOMER SITE PLANNING GUIDE
3
5
Check the location of the electrical outlets to be used.
The DocuColor 12 copier/printer uses a 20 amp, 120 volt outlet
receptacle. The DocuColor 12 printer uses a 15 amp, 120 volt outlet
receptacle. Configurations with external DFEs will require two or
more outlets.
receptacle. The DocuColor 12 printer uses a 15 amp, 120 volt outlet
receptacle. Configurations with external DFEs will require two or
more outlets.
Use the appropriate worksheets and electrical requirements in this
book to determine suitable outlets for the DocuColor 12. Record the
location of the outlets nearest to the copier/printer rear panel on your
site drawing.
book to determine suitable outlets for the DocuColor 12. Record the
location of the outlets nearest to the copier/printer rear panel on your
site drawing.
For specific requirements for the external DFE, refer to the
documentation for the external DFE.
documentation for the external DFE.
6
The space requirements shown in the site template are needed for
normal operator functions and routine service. This space must be
free of any obstructions, either fixed or movable. This space must
not be used as a traffic area or as a storage area. These templates
define the minimum space which is required and must not be
violated.
normal operator functions and routine service. This space must be
free of any obstructions, either fixed or movable. This space must
not be used as a traffic area or as a storage area. These templates
define the minimum space which is required and must not be
violated.
7
Refer to the manual installation requirements in case of an
infringement on the space requirements as shown on the site
templates. Also, refer to local installation rules.
infringement on the space requirements as shown on the site
templates. Also, refer to local installation rules.
8
Prepare a simple diagram that indicates the exact location
dimensions for correct installation of the copier, the printer or the
copier/printer. This diagram is used by the Carrier. Copy the form at
the end of this book to prepare a site drawing.
dimensions for correct installation of the copier, the printer or the
copier/printer. This diagram is used by the Carrier. Copy the form at
the end of this book to prepare a site drawing.
Refer to the Faultless Install section in the DocuColor 12 Student
Guide for more information about preparing this drawing.
Guide for more information about preparing this drawing.