Manualsbrain.com
  1. Manuais
  2. Marcas
  3. Cisco
  4. Cisco Unified MeetingPlace 5.3
  5. Manual De Manutenção

Cisco Cisco Unified MeetingPlace 5.3 Manual De Manutenção

Download
Página de 10
 
6
Hard Disk Replacement Procedure for the Cisco MeetingPlace 8106
OL-6460-01
  How to Replace the Hard Disk
Backing up the Database
Back up the Cisco MeetingPlace 8106 database before you replace the hard disk. (You can use the 
backup to restore your data if there is a problem after the installation.) We recommend that you back up 
your database immediately before replacing the hard disk.
Note
Use the Cisco MeetingPlace Backup Gateway to back up your database. For information on how to 
install, configure, and use the Cisco MeetingPlace Backup Gateway, see the Administrator’s Guide for 
Cisco MeetingPlace Backup Gateway Release 5.3.
Powering Down the Cisco MeetingPlace 8106
Note
As a courtesy, notify any current users that you are powering down the Cisco MeetingPlace 8106.
Step 1
Access the CLI.
Step 2
Log in as an administrator. The tech$ prompt appears.
Step 3
To stop new Cisco MeetingPlace activity, enter down. A verification prompt appears.
Step 4
At the prompt, enter y. The power down cycle begins.
Step 5
Wait about 2 minutes for the power down cycle to complete.
Step 6
At the tech$ prompt, enter halt. A verification prompt appears.
Step 7
At the prompt, enter y.
Step 8
Locate the power switch on the back of the Cisco MeetingPlace 8106 and turn it to the off position (“O”). 
Step 9
Remove the power cable from the back of the Cisco MeetingPlace 8106.
How to Replace the Hard Disk
Your Cisco MeetingPlace 8106 has two hard disks. One hard disk stores data and the other hard disk is 
used to backup the first hard disk. The hard disk in the top drive slot is the primary hard disk that is used 
to store your data.
Replacing a hard disk for the Cisco MeetingPlace 8106 consists of the following activities:
•
•
•