Cisco Cisco Catalyst 6500 Series Network Analysis Module (NAM-1 NAM-2) Guia Da Instalação

This section describes how to install and verify the operation of the NAM in the Catalyst 6500 series 
switch, the Catalyst 6000 series switch, and the Cisco 7600 series router, it and contains the following 
sections:

The Catalyst 6006 and 6506 switch chassis have 6 slots, the Catalyst 6009 and 6509 switch chassis
have 9 slots, and the Catalyst 6513 switch chassis has 13 slots. The NAM can occupy any slot that is not 
occupied by a supervisor engine in the Catalyst 6500 series switch, the Catalyst 6000 series switch, or 
Cisco 7600 series router. 

The Catalyst 6509-NEB switch has vertical slots numbered 1 to 9 from right to left. Install the modules 
with the component side facing to the right.

Make sure that you install switching-module filler plates, which are blank switching-module carriers, in 
the empty slots to maintain consistent airflow through the switch chassis.

This section describes how to remove an existing module from a chassis slot.

During this procedure, wear grounding wrist straps to avoid ESD damage to the module. Do not directly 
touch the backplane with your hand or any metal tool, or you could shock yourself.

To remove a supervisor engine or module from the chassis, perform these steps:

Disconnect any network interface cables attached to the supervisor engine or module.

The NAM does not have any interface cable connections.

Verify that the captive installation screws on all of the modules in the chassis are tight. 

This action ensures that the space created by the removed module is maintained.