Cisco Cisco ONS 15600 SDH Multiservice Provisioning Platform (MSPP) Guia Da Instalação
3
Upgrading the Cisco ONS 15600 SDH to Release 9.0
78-18839-01
Before You Begin
NTP-U417 Prepare for the Release 9.0 Upgrade
Step 1
Read the Release Notes for Cisco ONS 15600 SDH Release 9.0.
Step 2
Using the CTC software, log into the node that you are upgrading. For detailed instructions, refer to the
Cisco ONS 15600 SDH Procedure Guide.
Cisco ONS 15600 SDH Procedure Guide.
Note
You cannot open an SDH node in the same CTC session where a SONET node is active.
Step 3
Complete the
.
Step 4
Disable all other Ethernet devices (such as a dial-up adapter) on the workstation that runs CTC. For
instructions, contact the Cisco TAC.
instructions, contact the Cisco TAC.
Note
If you have multiple IP addresses on your workstation, you should remove them; you cannot run
ONS 15600 SDH Software R9.0 if multiple IP addresses are configured.
ONS 15600 SDH Software R9.0 if multiple IP addresses are configured.
Step 5
If you have multiple ONS 15600 SDH nodes configured in the same IP subnet, ensure that only one is
connected to a router. Otherwise, the remaining nodes might be unreachable. Refer to the
Cisco ONS 15600 Reference Manual for LAN-connection suggestions.
connected to a router. Otherwise, the remaining nodes might be unreachable. Refer to the
Cisco ONS 15600 Reference Manual for LAN-connection suggestions.
Step 6
Verify that TSC cards are installed in Slots 5 and 10, and that the TSC in Slot 10 is active.
Step 7
If the TSC in Slot 5 is active, select the slot, and right-click to display a shortcut menu. Click the Soft
reset Card button. The reset takes a few minutes, and resets the TSC card in Slot 10 as the active TSC.
reset Card button. The reset takes a few minutes, and resets the TSC card in Slot 10 as the active TSC.
Step 8
Complete the
.
Stop. You have completed this procedure.
Purpose
This procedure steps you through the critical information checks and tasks
you must complete before beginning an upgrade.
you must complete before beginning an upgrade.
Tools/Equipment
PC or UNIX workstation
Cisco ONS 15600 SDH nodes to upgrade
Cisco ONS 15600 SDH Software 9.0 (CD or soft copy)
Prerequisite Procedures None
Required/As Needed
Required
Onsite/Remote
Onsite or remote
Security Level
Superuser