Cisco Cisco ONS 15600 SDH Multiservice Provisioning Platform (MSPP) Guia Da Instalação
5
Upgrading the Cisco ONS 15600 SDH to Release 9.0
78-18839-01
DLP- U440 Verify CTC Workstation Requirements
NTP-U418 Back Up the Software Release Database
Note
Multiplex Section-Shared Protection Ring
(
MS-SPRing nodes only) The database must be backed up prior
to locking the MS-SPRing. To restore a software database, a backup file of that database must be
available.
available.
Step 1
Log into CTC. For detailed instructions, refer to the Cisco ONS 15600 SDH Procedure Guide. If you are
already logged in, continue with Step 2.
already logged in, continue with Step 2.
Step 2
In CTC node view, click the Maintenance tab and then click the Software button.
Step 3
Verify that the correct working and protect versions of the software are installed.
Step 4
(Optional) Cisco recommends that you manually log critical information by either writing it down or
printing screens where applicable. Use
printing screens where applicable. Use
to determine the information you should log. Complete
the table (or your own version) for every node in the network.
Purpose
This procedure preserves all Software R8.0 configuration data for your
network before performing the upgrade.
network before performing the upgrade.
Tools/Equipment
PC or UNIX workstation
Prerequisite Procedures
Required/As Needed
Required
Onsite/Remote
Onsite or remote (but in the presence of the workstation)
Security Level
Maintenance and above
Table 1
Manually Logged Data
Item
Record Data Here (If Applicable)
IP address of the node
Node name
Timing settings
Data Communications Channel (DCC) connections; list all
optical ports that have DCCs activated
optical ports that have DCCs activated
User IDs (List all, including at least one Superuser)
Inventory; do a print screen from the Inventory window
Active TSC
Note
The TSC card in Slot 10 must be the active TSC card for
an upgrade.
an upgrade.
Slot 5 or Slot 10 (circle one). If the
TSC in Slot 5 shows active status,
the slot and right-click to display a
shortcut menu. Click Soft reset
Card. The reset takes a few
minutes, and resets the TSC card in
Slot 10 as the active TSC.
TSC in Slot 5 shows active status,
the slot and right-click to display a
shortcut menu. Click Soft reset
Card. The reset takes a few
minutes, and resets the TSC card in
Slot 10 as the active TSC.
SSXC preferred copy
Slot 6/7 or Slot 8/9 (circle one)
Network information; do a print screen from the Provisioning tab
in network view.
in network view.
Current configuration: SNCP, linear, etc. Do print screens as
needed.
needed.