Cisco Cisco ONS 15454 SDH Multiservice Provisioning Platform (MSPP) Guia Da Instalação

After performing the procedures in this document, upgrade any XC10G cards with XC-VXL cards, 
as necessary. For detailed instructions, refer to the Cisco ONS 15454 SDH Procedure Guide.

Read the Release Notes for Cisco ONS 15454 SDH Release 4.1.x.

Log into the node that you will upgrade. For detailed instructions, refer to the Cisco ONS 15454 SDH 
Procedure Guide.

Complete the 

.

Disable all other Ethernet devices (such as a dial-up adapter) on a PC or workstation that runs CTC. For 
more information, refer to the Cisco Technical Assistance Center (TAC) web site at 
http://www.cisco.com/tac. 

If you have multiple IP addresses on your PC or workstation, you should remove them; you cannot install 
Software R4.1.x if multiple IP addresses are configured. 

Complete the 

.

Complete the 

.

When you have completed the procedures for this section, proceed with the 

.

This procedure steps you through the critical information checks and 
procedures you must complete before beginning an upgrade.

ONS 15454 SDH nodes to upgrade; PC or UNIX workstation; 
Cisco ONS 15454 SDH R4.1.x software

Prerequisite Procedures None

Required

Onsite or remote

Superuser

This task verifies all PC or UNIX workstation hardware and software 
requirements. Use this task before upgrading the workstation to run CTC 
Software R4.1.x.

PC or UNIX workstation

Prerequisite Procedures None

Required

Onsite or remote (but in the presence of the workstation)

Superuser