Cisco Cisco TelePresence MX700 Referências técnicas

D15335.04

 Cisco TelePresence MX700 and MX800 API Reference Guide CE8.2, JUNE 2016. 

Copyright © 2016 Cisco Systems, Inc. All rights reserved. 

101

Cisco TelePresence MX700 and MX800

API Reference Guide

xConfiguration Video Output Connector [2] CEC Mode

This setting only applies to MX800 Single.
This video output (HDMI) supports Consumer Electronics Control (CEC). When this setting is 

On (default is Off), the system will use CEC to set the monitor in standby when the system itself 

enters standby. Likewise the system will wake up the monitor when the system itself wakes 

up from standby. For this to happen, the monitor that is connected to the output must be CEC 

compatible and CEC must be configured on the monitor.

Note that the different manufacturers uses different marketing names for CEC, for example 

Anynet+ (Samsung); Aquos Link (Sharp); BRAVIA Sync (Sony); HDMI-CEC (Hitachi); Kuro Link 

(Pioneer); CE-Link and Regza Link (Toshiba); RIHD (Onkyo); HDAVI Control, EZ-Sync, VIERA Link 

(Panasonic); EasyLink (Philips); and NetCommand for HDMI (Mitsubishi).

Requires user role: ADMIN
Default value: Off

USAGE:

xConfiguration Video Output Connector 

 CEC Mode: 

where

: Unique ID that identifies the video output connector. Range: 2..2

: Off/On
Off: Disable CEC control
On: Enable CEC control

xConfiguration Video Output Connector [1..3] MonitorRole

The monitor role describes which video streams will be shown on the monitor connected to this 

video output connector. Together the Video Monitors setting and the MonitorRole settings for 

all outputs define which layout (video streams) will be shown on each monitor.

Requires user role: ADMIN
Default value: Auto

USAGE:

xConfiguration Video Output Connector 

 MonitorRole: 

where

: Unique ID that identifies the video output connector. Range: 1..3

: Auto/First/Second/PresentationOnly/Third/Recorder

Auto: The system will detect when a monitor is connected, and a monitor role (First, 

Second, Third) that corresponds with the Video Monitors setting will be assigned 

automatically.

First/Second/Third: Define the role of the monitor in a multi-monitor setup. In a single-

monitor setup, there is no difference between First, Second and Third.
PresentationOnly: Show presentation video stream if active, and nothing else. Monitors/

outputs with this monitor role are disregarded by the Video Monitors setting.

Recorder: Show all participants, including the local main video (self-view). If active, also 

show the presentation. Monitors/outputs with this monitor role are disregarded by the 

Video Monitors setting.

Introduction

About the API

xConfiguration

Appendices

xCommand

xStatus



xConfiguration