Cisco Cisco Unified MeetingPlace for Microsoft Office Communicator Guia De Configuração Rápida
Integrating Cisco Unified MeetingPlace with Cisco Unified Communications Manager
Configuring a SIP Trunk Security Profile in Cisco Unified Communications Manager for Cisco Unified MeetingPlace
2
•
•
•
•
Configuring a SIP Trunk Security Profile in Cisco Unified
Communications Manager for Cisco Unified MeetingPlace
Communications Manager for Cisco Unified MeetingPlace
We recommend that you do the following:
•
Create a SIP trunk security profile in Cisco Unified Communications Manager specifically for
Cisco Unified MeetingPlace.
Cisco Unified MeetingPlace.
•
Apply this SIP trunk security profile to SIP trunks to Cisco Unified MeetingPlace systems.
Before You Begin
•
This task applies only in Cisco Unified Communications Manager environments.
•
You perform this task in the Cisco Unified Communications Manager Administration pages.
Because the pages and menus vary by release, you should check the Cisco Unified
Communications Manager online help for step-by-step instructions for your specific release.
Because the pages and menus vary by release, you should check the Cisco Unified
Communications Manager online help for step-by-step instructions for your specific release.
Procedure
Step 1
Go to http://ccm-server/, where ccm-server is the fully-qualified domain name or IP address of the
Cisco Unified Communications Manager server.
Cisco Unified Communications Manager server.
Step 2
Sign in with your Cisco Unified Communications Manager administrator username and password.
Step 3
Click System > Security Profile > SIP Trunk Security Profile.
Step 4
Click Add New.
Step 5
Configure fields described in
Table 1
Fields for SIP Trunk Security Profile Configuration
Field
Action
Name
Enter a name, such as SIP Trunk Security Profile for Cisco Unified
MeetingPlace.
MeetingPlace.
Device Security Mode
Select Non Secure.
Incoming Transport Type
Keep the default value of TCP+UDP.
If other values are available for this field, then you may instead
select the value that matches the
select the value that matches the
setting for this
Cisco Unified Communications Manager node on the
.
Outgoing Transport Type
We recommend that you select UDP.
Enable Digest Authentication
Uncheck this check box.