Cisco Cisco Web Security Appliance S170 Guia Do Utilizador

The AsyncOS Command Line Interface (CLI) is an interactive interface designed to allow you to 
configure and monitor the Web Security appliance. The commands are invoked by entering the command 
name with or without any arguments. If you enter a command without arguments, the command prompts 
you for the required information.

The Command Line Interface is accessible using SSH on IP interfaces that have been configured with 
these services enabled, or using terminal emulation software on the serial port. By default, SSH is 
configured on the Management port. 

This section describes the rules and conventions of the AsyncOS Command Line Interface.

Access to the CLI varies depending on the management connection method chosen while setting up the 
appliance. The factory default username and password are listed next. Initially, only the admin user 
account has access to the CLI. You can add other users with differing levels of permission after you have 
accessed the CLI for the first time using the admin account. The System Setup Wizard prompts you to 
change the password for the admin account. 

You can also reset the admin account password at any time using the 

passwd

 command.

You can connect using one of the following methods:

Ethernet. Start an SSH session with the IP address of the Web Security appliance. The factory 
default IP address is 192.168.42.42. SSH is configured to use port 22.