Cisco Cisco Web Security Appliance S370 Guia Do Utilizador

To access the web interface, your browser must support and be enabled to accept JavaScript and cookies. 
It must be able to render HTML pages containing Cascading Style Sheets (CSS). 

The Cisco Web Security Appliance follows the Target Environments set by YUI: 
http://yuilibrary.com/yui/environments/ 

Your session automatically times out after 30 minutes of inactivity.

Some buttons and links in the web interface cause additional windows to open. Therefore, you may need 
to configure the browser’s pop-up blocking settings in order to use the web interface.

Only use one browser window or tab at a time to edit the appliance configuration. Also, do not edit the 
appliance using the web interface and the CLI at the same time. Editing the appliance from multiple 
places concurrently results in unexpected behavior and is not supported.

By default, the HTTP and HTTPS interfaces are not enabled on virtual appliances. To enable these 
protocols, you must use the command-line interface. 

Access the command-line interface. See 

Run the 

interfaceconfig

 command. 

Pressing Enter at a prompt accepts the default value. 

Look for the prompts for HTTP and HTTPS and enable the protocol(s) that you will use. 

If you are using a virtual appliance, see 

. 

Open a browser and enter the IP address (or hostname) of the Web Security appliance. If the appliance 
has not been previously configured, use the default settings:

https://192.168.42.42:8443

 

-or-

http://192.168.42.42:8080

 

where 

192.168.42.42 

is the default IP address, and

 8080 

is the default admin port setting for HTTP, 

and 

8443

 is default admin port for HTTPS.

Otherwise, if the appliance is currently configured, use the IP address (or host name) of the M1 port.