Cisco Cisco Web Security Appliance S690 Guia Do Utilizador
1-3
AsyncOS 9.0.1 for Cisco Web Security Appliances User Guide
Chapter 1 Introduction to the Product and the Release
Using the Appliance Web Interface
Web Interface Browser Requirements
To access the web interface, your browser must support and be enabled to accept JavaScript and cookies.
It must be able to render HTML pages containing Cascading Style Sheets (CSS).
It must be able to render HTML pages containing Cascading Style Sheets (CSS).
The Cisco Web Security Appliance follows the Target Environments set by YUI:
http://yuilibrary.com/yui/environments/
http://yuilibrary.com/yui/environments/
Your session automatically times out after 30 minutes of inactivity.
Some buttons and links in the web interface cause additional windows to open. Therefore, you may need
to configure the browser’s pop-up blocking settings in order to use the web interface.
to configure the browser’s pop-up blocking settings in order to use the web interface.
Note
Only use one browser window or tab at a time to edit the appliance configuration. Also, do not edit the
appliance using the web interface and the CLI at the same time. Editing the appliance from multiple
places concurrently results in unexpected behavior and is not supported.
appliance using the web interface and the CLI at the same time. Editing the appliance from multiple
places concurrently results in unexpected behavior and is not supported.
Enabling Access to the Web Interface on Virtual Appliances
By default, the HTTP and HTTPS interfaces are not enabled on virtual appliances. To enable these
protocols, you must use the command-line interface.
protocols, you must use the command-line interface.
Step 1
Access the command-line interface. See
Step 2
Run the
interfaceconfig
command.
Pressing Enter at a prompt accepts the default value.
Look for the prompts for HTTP and HTTPS and enable the protocol(s) that you will use.
Accessing the Appliance Web Interface
Before You Begin
If you are using a virtual appliance, see
.
Step 1
Open a browser and enter the IP address (or hostname) of the Web Security appliance. If the appliance
has not been previously configured, use the default settings:
has not been previously configured, use the default settings:
https://192.168.42.42:8443
-or-
http://192.168.42.42:8080
where
192.168.42.42
is the default IP address, and
8080
is the default admin port setting for HTTP,
and
8443
is default admin port for HTTPS.
Otherwise, if the appliance is currently configured, use the IP address (or host name) of the M1 port.