Cisco Cisco Fiber IGESM Switch Module for IBM
16
Release Notes for the Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter
43W7806
Open Caveats
•
If you use Internet Explorer Version 5.5 and select a URL with a nonstandard port at the end of the
address (for example, www.cisco.com:84), you must enter http:// as the URL prefix. Otherwise, you
cannot start the device manager.
address (for example, www.cisco.com:84), you must enter http:// as the URL prefix. Otherwise, you
cannot start the device manager.
Open Caveats
There are no open caveats in this release.
Resolved Caveats
These caveats were resolved in Cisco IOS Release 12.1(22)EA12:
•
CSCso23104
This error message no longer appears when you log in to the switch:
SCHAN ERROR INTR: unit=0 SRC=13 DST=15 OPCODE=20 ERRCODE=66
•
CSCso70964
The switch now correctly saves the no errdisable detect cause dhcp-rate-limit global
configuration command to the saved configuration. (In previous releases, the command was not in
the saved configuration after you reloaded the switch.)
configuration command to the saved configuration. (In previous releases, the command was not in
the saved configuration after you reloaded the switch.)
•
CSCsm71433
When the guest VLAN is an access VLAN and the dot1x control-direction in interface
configuration command is configured on a port, a new device is now placed in the guest VLAN when
a supplicant is not available.
configuration command is configured on a port, a new device is now placed in the guest VLAN when
a supplicant is not available.
•
CSCsl98167
A port now passes packets when both an access control list (ACL) and a service policy are
configured on the port.
configured on the port.
•
CSCsl63734
When the Cisco IGESM switch is connected to an Advanced Management Module (AMM) and both
are in protected mode, the link no longer stays down after the AMM reboots.
are in protected mode, the link no longer stays down after the AMM reboots.
Documentation Updates
This section provides updates to the product documentation:
•
•
•
These changes will be included in the next revision of the Cisco IGESM blade switch documentation.