Cisco Cisco Fiber IGESM Switch Module for IBM Release Notes

If you use Internet Explorer Version 5.5 and select a URL with a nonstandard port at the end of the 
address (for example, www.cisco.com:84), you must enter http:// as the URL prefix. Otherwise, you 
cannot start the device manager.

There are no open caveats in this release.

These caveats were resolved in Cisco IOS Release 12.1(22)EA12:

CSCso23104 

This error message no longer appears when you log in to the switch:

SCHAN ERROR INTR: unit=0 SRC=13 DST=15 OPCODE=20 ERRCODE=66

CSCso70964

The switch now correctly saves the no errdisable detect cause dhcp-rate-limit global 
configuration command to the saved configuration. (In previous releases, the command was not in 
the saved configuration after you reloaded the switch.)

CSCsm71433

When the guest VLAN is an access VLAN and the dot1x control-direction in interface 
configuration command is configured on a port, a new device is now placed in the guest VLAN when 
a supplicant is not available. 

CSCsl98167

A port now passes packets when both an access control list (ACL) and a service policy are 
configured on the port. 

CSCsl63734

When the Cisco IGESM switch is connected to an Advanced Management Module (AMM) and both 
are in protected mode, the link no longer stays down after the AMM reboots.

 

This section provides updates to the product documentation:

These changes will be included in the next revision of the Cisco IGESM blade switch documentation.