Cisco Cisco Gigabit Ethernet Switch Module (CGESM) for HP
14
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(44)SE and Later
464831-006
Open Caveats
•
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class System Message Guide, Cisco
IOS Release 12.2(25)SE
IOS Release 12.2(25)SE
Open Caveats
These sections describe the open caveats with possible unexpected activity in this software release:
•
•
Open IOS Caveats
These severity 3 Cisco IOS configuration caveats apply to the CGESM switch:
•
CSCee08109
If a port-based ACL (PACL) is applied to an 802.1x-enabled port and the client is then disconnected
from that port, the PACL is not removed from the port.
from that port, the PACL is not removed from the port.
There is no workaround.
•
CSCeg04311
When you power on or restart a switch that does not have a config.text file in flash memory, the
switch tries to get configuration files from a TFTP server. If the configuration files are not found,
the switch automatically configures the service config global configuration command, which causes
the switch to continue searching (in the background) for the expected configuration files.
switch tries to get configuration files from a TFTP server. If the configuration files are not found,
the switch automatically configures the service config global configuration command, which causes
the switch to continue searching (in the background) for the expected configuration files.
If the service config command does not find the configuration files, these error messages appear:
%Error opening tftp://255.255.255.255/network-confg (Timed out)
%Error opening tftp://255.255.255.255/cisconet.cfg (Timed out)
%Error opening tftp://255.255.255.255/router-confg (Timed out)
%Error opening tftp://255.255.255.255/ciscortr.cfg (Timed out)
These system messages also appear:
00:01:40: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from
(tftp://255.255.255.255/network-confg) failed
00:01:40: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from
(tftp://255.255.255.255/cisconet.cfg) failed
00:01:40: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from
(tftp://255.255.255.255/switch-confg) failed
00:01:40: %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from
(tftp://255.255.255.255/ciscortr.cfg) failed
These messages are for information only. There is no problem with the switch operation.
Because the switch automatically configures the service config global configuration command, it is
in the switch startup-config file when you save the running-config file. This command runs every
time the switch is restarted, even if a config.text configuration file is in the switch flash memory.
in the switch startup-config file when you save the running-config file. This command runs every
time the switch is restarted, even if a config.text configuration file is in the switch flash memory.
The workaround is to prevent these messages from being generated. To do this, enter the switch
configuration mode, and issue the no service config command. Save the configuration to flash by
using the copy running-config to startup-config command. The preceding error and system
messages no longer appear and do not appear when the switch is restarted.
configuration mode, and issue the no service config command. Save the configuration to flash by
using the copy running-config to startup-config command. The preceding error and system
messages no longer appear and do not appear when the switch is restarted.
•
CSCsd86177
When you remove and reconfigure a loopback interface, it does not appear in the ifTable.