Cisco Cisco Agent Desktop 8.5 Referências técnicas
Diagnostic Procedures
May 2007
231
Network Check
■
On the CAD services computer, verify that the IP address in the registry value
HKEY_LOCAL_MACHINE\SOFTWARE\Spanlink\CAD\Site Setup\IOR
HOSTNAME is the correct IP address of the public NIC.
HKEY_LOCAL_MACHINE\SOFTWARE\Spanlink\CAD\Site Setup\IOR
HOSTNAME is the correct IP address of the public NIC.
■
To view information about the NICs on the computer, open a command
window and type ipconfig /all.
window and type ipconfig /all.
■
Verify that the hostname and IP address are as expected.
■
Verify that the subnet mask is correct. It is probably 255.255.255.0.
■
If there are multiple NICs enabled, verify that the public NIC comes before the
private NIC:
private NIC:
1. In the Control Panel, double-click Network and Dial-up Connections.
2. From the menu bar, choose Advanced > Advanced Settings.
3. On the Adapters and Bindings tab, verify that the NICs are in the correct
order in the Connections pane.
■
Check the network connectivity by pinging from the CAD services computer to
others in the configuration, for example, the Unified ICM computer. Then
reverse it by pinging from the other computers to the CAD services computer.
Do this using both hostnames and IP addresses and ensure that the ping
results match.
others in the configuration, for example, the Unified ICM computer. Then
reverse it by pinging from the other computers to the CAD services computer.
Do this using both hostnames and IP addresses and ensure that the ping
results match.
■
If hostnames are used, verify that the appropriate DNS, WINS, and hosts files
are correct.
are correct.
■
If there is a problem connecting to a particular service, try typing telnet <IP
address/hostname> <port> in a command window, where <IP
address/hostname> is the IP address or hostname of the computer where
the service is running and <port> is the port used by the service.
address/hostname> <port> in a command window, where <IP
address/hostname> is the IP address or hostname of the computer where
the service is running and <port> is the port used by the service.
■
www.ethereal.com
) to analyze
network communications.
■
If security or firewall software is running on the computer, check its reports
and/or logs to see if it is blocking any communication or ports.
and/or logs to see if it is blocking any communication or ports.
Memory Check
■
Ensure that the amount of memory on the computer is at least the minimum
required for CAD and other installed software. If the amount of memory is
below the recommended level, it could be the source of the problem.
required for CAD and other installed software. If the amount of memory is
below the recommended level, it could be the source of the problem.
■
Use Microsoft Perfmon (perfmon.exe) to perform most memory checking.
— Add the following counters for _Total and process of interest:
■
Private Bytes
■
Virtual Bytes