Cisco Cisco TelePresence MX700 Folheto
Manual registration of the endpoint
(continued...)
Adding a new device
(continued...)
Product Specific Configuration Layout
If registered to TMS (Cisco TelePresence Management Suite) or
CTSMAN (Cisco TelePresence Manager), configure the product
specific configuration layout as appropriate.
6. Navigate to the Product Specific Configuration Layout section and
configure the items according to your preferred settings.
Room Name (from Exchange(R)): This is the Exchange Conference Room
Room Name (from Exchange(R)): This is the Exchange Conference Room
Name. It is used for scheduling meetings where this TelePresence system
participates. This setting must match the e-mail address used in Exchange
exactly. Example: room123@example.com. Maximum length: 64.
Web Access: This parameter indicates whether the device accepts
connections from a web browser or other HTTP clients. Disabling the
web server functionality of the device will block access to the phone's
internal web pages and certain support capabilities, but will not
degrade normal operation. Default: Disabled.
NOTE:
For the Web
Access configuration change to take effect, please make sure to Save
and RESET the device (do not use Restart or Apply Config).
SSH Access: This parameter indicates whether the device accepts SSH
connections. Disabling the SSH server functionality of the device will
block certain support capabilities such as log file collection but will not
degrade normal operation. Default: Disabled.
Default Call Protocol: This parameter sets the default call protocol of the
device. This device only supports SIP when registering to Cisco Unified
CM. Default: SIP.
Quality Improvement Server: Specifies a host name or IP address of a
remote system to collect quality improvement reports from the device.
Default: ““ and Maximum length: 256.
Multipoint Mode: Choose Use Endpoint to use the built-in MultiSite
feature or choose Use Media Resource Group List to use the Conference
Bridge feature on Cisco Unified CM.
NOTE:
Applies to endpoints having
MultiSite capability and having the option installed.
Click Save and Apply Config.
How to configure the product specific configuration layouts for the endpoint.
Log in to Cisco Unified CM Administration and navigate to Device > Phone.
Log in to Cisco Unified CM Administration and navigate to Device > Phone.
6
Device
Phone
Cisco TelePresence Endpoints running TC6 and Cisco Unified Communications Manager 9.0
Quick Reference Guide
D14996.01 Administering TC6 Endpoints on CUCM 9.0, January 2013.
www.cisco.com — Copyright © 2013 Cisco Systems, Inc. All rights reserved.
20
Contents
Introduction
Endpoint configuration
CUCM configuration
Setting passwords
Appendices
CUCM configuration