Cisco Cisco TelePresence MX700 Folheto

Cisco TelePresence Endpoints running TC6 and Cisco Unified Communications Manager 9.0 

Quick Reference Guide

D14996.01 Administering TC6 Endpoints on CUCM 9.0, January 2013. 

www.cisco.com — Copyright © 2013 Cisco Systems, Inc. All rights reserved. 

29

API 

Touch

How to factory reset the endpoint

You can reset the endpoint to its factory defaults by:

•  The Touch controller, if you have one.
•  The web interface, which available for all endpoints.
•  The command line interface by issuing an API command.
•  The power button (SX20/EX60/EX90).

It is not possible to undo a factory reset.

When factory resetting the endpoint the following happens: 

•  The call logs will be deleted.
•  All system parameters will be reset to default values. 
•  All files that have been uploaded to the system will be 

deleted. 

•  The Release and Option keys will be preserved.
•  Automatic restart of the system. 

Notification on the main screen 
The system will confirm the factory reset by displaying a 

notification on the main screen when up and running again. 

The notification disappears after approximately 10 seconds.

Basic configuration after the factory reset 
This document do not describe the basic configuration of 

the endpoint, such as user roles, network configuration, date 

& time, or location settings, etc. You can read about these 

topics in the

 

1.  Tap gently on the Touch screen if the unit is in sleep 

mode.

2.  Navigate to 

3.  Tap the 

button.

4.  The system will revert to the default factory settings and 

automatically restart. This will take a few minutes.

1.  Open a web browser and enter the IP address of the 

video system in the address bar.

2.  Navigate to 

.

3.  Read the provided information carefully before you check 

the 

 check box

4.  Click 

.

5.  The system will revert to the default factory settings and 

automatically restart. This will take a few minutes.

Tap 

on the Touch 

controller to find the system's IP address (IPv4 or IPv6).

Power 

button 

1.  Power down the system by pressing gently and hold the 

power button until the system shuts down. The power 

LED turns off.

2.  Press gently and hold the power button for 10 seconds. 

During this period the power LED will remain off. 

3.  Release the button and within four seconds, press twice. 

During this period the power LED will blink. 

4.  The system will revert to the default factory settings and 

automatically restart. When up and running again the LED 

lights continuously.

If you failed to press the power button twice within the 

four seconds, the system will not revert to the default 

factory settings, and you will not see the confirmation 

message. If this happens, go back to Step 1.

1.  Start a command line interface (for example PuTTY). 

Enter the host name (or IP address) of the codec and set 

connection type to SSH.

2.  Log in with the appropriate username and password.

3.  Run the following command: 

xCommand SystemUnit 

FactoryReset Confirm: Yes

4.  The system will revert to the default factory settings and 

automatically restart. This will take a few minutes.

Applies to SX20/EX60/EX90

WEB

 

Contents

Introduction

Endpoint configuration

CUCM configuration

Setting passwords

Appendices

Appendices